[RE-wrenches] Cutting rail

[frenergy]

Any suggestions for cutting rail with a Sawzall?  Many times at the end 
of a run of PVs there could be 5-6" of rail (in this case DPW P8).  I 
like to use a circular saw but sometimes I don't have enough clearance 
once the rail and panels are installed.  The sawzall works but I'm 
looking for a blade that doesn't load up with aluminum too fast and cuts 
without too much vibration.  Other ideas?

Thanks,

Bill

Feather River Solar Electric
Bill Battagin, Owner
4291 Nelson St.
Taylorsville, CA 95983
530.284.7849
CA Lic 874049
www.frenergy.net


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus