[RE-wrenches] partial data loss Mate 3s

Mac Lewis maclewis1 at gmail.com
Tue Oct 25 09:10:12 PDT 2022


Hello Wrenches,

I am trying to figure out a tricky problem.  I have a customer with a Mate
3s, most current firmware 1.4.7 paired with a radian and a couple of FM60s
and some Lithium batteries.  We have experienced partial data loss,
particularly of the Mate 3s generator start parameters.  These parameters
seem to go back to defaults and it defaults to an AGS disabled state.

  At first I thought it was due to electrical storms, because we've had
quite a bit of lightning lately, but now I'm not sure.  The Cat6 run is
about 80' or something like that, so it could be some induction.

Anyone seen anything like this?  Same parameters were lost from first data
loss to following data loss.  Kind of strange.  I haven't visited the site
so I may not b getting the full picture.

Thanks

-- 



Mac Lewis

*"Yo solo sé que no sé nada." -Sócrates*
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org/attachments/20221025/8fff821b/attachment.htm>


More information about the RE-wrenches mailing list