Outback MX problem [RE-wrenches]
Matt Tritt
solarone at charter.net
Wed May 28 12:42:57 PDT 2008
<x-flowed>
Ron,
Since the MX thinks that the batteries are virtually full all the time,
"force bulk" is simply overriding the controller programming to effect a
charge, I would take OutBack up on the offer and call it good. I'm
curious as to why you have the bulk point set so high?
Matt T
Ron Young wrote:
>
> I'm having a problem with an Outback MX going into sleep mode and
> showing incorrect voltage on the input. It's a single 3524 inverter
> with a 4KS25 Surrette battery charged by a Whisper 100 and a 680 watt
> array (Evergreen 170's) wired in two strings for 48v. The only time
> the MX will charge is if a charge is initiated via FORCE BULK mode or
> if the customer turns on her vacuum cleaner and it draws down the
> batt. voltage then the MX kicks in. She says she sees the pv output
> voltage drop from 70 (sunny day) to as low as 24 then start building
> up again. If it stays around 60 then the MX keeps charging but once
> it gets back up to 70 then MX cuts out. Bulk set point is at 29.4.
>
> Actual battery voltage measured at the terminals is 25.1 today but
> the MX says 29.1.
>
> Outback wants to replace the unit but I'm not convinced yet that it's
> defective, just wondering if maybe something else is going on that
> I've overlooked. The above behaviour is the same whether there is
> wind or no wind so I've ruled out a conflict with the Whisper
> controller.
>
> Ron Young
>
>
> - - - -
> Hosted by Home Power magazine
>
> To send a message: RE-wrenches at topica.com
>
> Archive of previous messages:
> http://lists.topica.com/lists/RE-wrenches/read
>
> List rules & how to change your email address:
> www.mrsharkey.com/wrenches/etiquette.php
>
> Check out participant bios: www.mrsharkey.com/wrenches/
>
> Moderator: michael.welch at homepower.com
>
>
- - - -
Hosted by Home Power magazine
To send a message: RE-wrenches at topica.com
Archive of previous messages: http://lists.topica.com/lists/RE-wrenches/read
List rules & how to change your email address: www.mrsharkey.com/wrenches/etiquette.php
Check out participant bios: www.mrsharkey.com/wrenches/
Moderator: michael.welch at homepower.com
--^----------------------------------------------------------------
This email was sent to: michael.welch at re-wrenches.org
EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: RE-wrenches-unsubscribe at topica.com
For Topica's complete suite of email marketing solutions visit:
http://www.topica.com/?p=TEXFOOTER
--^----------------------------------------------------------------
</x-flowed>
More information about the RE-wrenches
mailing list