Hidden Low profile conduit through roof - flashing? [RE-wrenches]
Aaron Wellendorf
Aaron at stellarenergy.com
Fri Dec 7 12:27:01 PST 2007
I have used a flat piece of flashing, knocked out the appropriately
sized conduit hole, installed a Myers hub, install an LB or SLB with a
close nipple, and installed it like a roof jack.
For even closer fit to the roof, use conduit all thread thru the sheet
metal with a sealing locknut on both sides. Caulk for extra protection.
If you're still worried about water leaking, cut a strip of sheet metal,
bend it into a V shape, and caulk it onto the flat sheet metal to make a
dam that directs water flow around the penetration point.
There are quite a few ways to skin this cat.
Aaron Wellendorf
- - - -
Hosted by Home Power magazine
To send a message: RE-wrenches at topica.com
Archive of previous messages: http://lists.topica.com/lists/RE-wrenches/read
List rules & how to change your email address: www.mrsharkey.com/wrenches/etiquette.php
Check out participant bios: www.mrsharkey.com/wrenches/
Moderator: michael.welch at homepower.com
--^----------------------------------------------------------------
This email was sent to: michael.welch at re-wrenches.org
EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: RE-wrenches-unsubscribe at topica.com
For Topica's complete suite of email marketing solutions visit:
http://www.topica.com/?p=TEXFOOTER
--^----------------------------------------------------------------
More information about the RE-wrenches
mailing list