AGS thru a MX? [RE-wrenches]

[Darren Emmons]

<x-flowed>

Dan, John

The AGS port on the MATE can only be a FX port for MATE versions less 
than equal to V3.50.  The updated MATE software (version 4.0 or greater) 
can use the FX or the FlexNet DC relay.


Darren Emmons
North Bend, WA


John Raynes wrote:
> 
> Dan,
> 
> Have you tried just setting the AGS port on the Mate to the hub port 
> number that you are using for the MX?  The Mate manual doesn't say that 
> you can do that, and as I read the AGS section, it kind of implies that 
> AGS only works with FX inverter devices.  But it doesn't explicitly say 
> that you can't use an MX.  I wouldn't see any great harm in trying if 
> you can't get a definitive answer from Outback.  Either they programmed 
> the functionality into the firmware or they didn't.  The MX aux outputs 
> only source 200mA as opposed to 700mA for the FX, but you can deal with 
> that with an interposing relay.
> 
> John Raynes
> RE Solar
> Torrey, UT
> 
> 
> At 09:05 AM 11/2/2007 -0400, you wrote:
> 
> 
>> was i dreaming --  was there ever a way of using the MX's aux out 
>> w/AGS from
>> the mate/hub? i found a little about "remote" in the MX manual, but 
>> not much
>> in the mate's. ( Outback folks were not real encouraging) -- could 
>> have sworn i
>> stumbled across it someplace. db
>>
>> Dan Brown
>>
>> Foxfire Energy
>> Professional Renewable Energy Systems
>> Service, and Installation
>> (802)-483-2564
>> www.Foxfire-Energy.com
>>
> 
> 
> - - - -
> Hosted by Home Power magazine
> 
> To send a message: RE-wrenches at topica.com
> 
> Archive of previous messages: 
> http://lists.topica.com/lists/RE-wrenches/read
> 
> List rules & how to change your email address: 
> www.mrsharkey.com/wrenches/etiquette.php
> 
> Check out participant bios: www.mrsharkey.com/wrenches/
> 
> Moderator: michael.welch at homepower.com
> 
> 
> 


- - - -
Hosted by Home Power magazine

To send a message: RE-wrenches at topica.com

Archive of previous messages: http://lists.topica.com/lists/RE-wrenches/read

List rules & how to change your email address: www.mrsharkey.com/wrenches/etiquette.php

Check out participant bios: www.mrsharkey.com/wrenches/

Moderator: michael.welch at homepower.com
--^----------------------------------------------------------------
This email was sent to: michael.welch at re-wrenches.org

EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: RE-wrenches-unsubscribe at topica.com

For Topica's complete suite of email marketing solutions visit:
http://www.topica.com/?p=TEXFOOTER
--^----------------------------------------------------------------


</x-flowed>