AGS problems with Outback system [RE-wrenches]
Jay Peltz, Peltz Power
jay at asis.com
Tue Dec 4 09:47:39 PST 2007
<x-flowed>
Hi Jonah,
I have had such problems.
I no longer reset the mate. When I have AGS problems, I get a new
mate and
send the other mate back to be reprogramed.
Its the only reliable fix I know of,
jay
peltz power
On Dec 4, 2007, at 9:21 AM, Jonah Liebes wrote:
>
>
> Hi All,
>
>
>
> I need help! I have an ongoing problem with the Automatic Generator
> Start on
> a (2) VFX 3624 system. The system is supplied by a rather small 800
> Wp solar
> array and (6) 12V seal batteries.
>
>
>
> Here's the problem: the starting of the back-up generator is not
> reliable.
> It will load start when the well kicks on as it's supposed to. It will
> usually volt start when the timed, low voltage threshold is
> reached, but not
> always.
>
>
>
> Also, if and when it does come on, it will "cycle" on and off every
> 15-60
> seconds. The cycling could go on for hours: on for up to a minute,
> then off
> for 15 or so seconds, then back on for a minute, then off again.
> One strange
> thing is that the cycling will occur even when the generator
> control is set
> to 'manual'. I do hear the relay in the Outback closing contacts which
> signals the gen to start, so I don't think it's the generator itself.
>
>
>
>
>
> I've just replaced the battery bank, added 300 Wp of PV and reset
> the Mate
> to factory defaults and reprogrammed it with Outback on the phone.
> Nothing
> has affected the problem though.
>
>
>
>
>
> Any help out there would be greatly appreciated. I've spent hours
> troubleshooting and head scratching with and without Outback tech
> support
> and nobody has figured it out yet.
>
>
>
>
>
> Thanks in advance,
>
>
>
>
>
>
>
> Jonah Liebes
>
>
- - - -
Hosted by Home Power magazine
To send a message: RE-wrenches at topica.com
Archive of previous messages: http://lists.topica.com/lists/RE-wrenches/read
List rules & how to change your email address: www.mrsharkey.com/wrenches/etiquette.php
Check out participant bios: www.mrsharkey.com/wrenches/
Moderator: michael.welch at homepower.com
--^----------------------------------------------------------------
This email was sent to: michael.welch at re-wrenches.org
EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: RE-wrenches-unsubscribe at topica.com
For Topica's complete suite of email marketing solutions visit:
http://www.topica.com/?p=TEXFOOTER
--^----------------------------------------------------------------
</x-flowed>
More information about the RE-wrenches
mailing list