HUP batteries [RE-wrenches]

[Matt Tritt]

<x-flowed>

Drake,

I can't testify as to the compliance of this, but I (almost) always 
remove the steel covers from the case. I do this because I have seen 
instances where the lids have been forced down by maintenance people 
hard enough to cause light contact between the cable and the case. If 
the case had been grounded, this would have been real exciting!

Matt T

Drake Chamberlin wrote:

>
> I have a possible install with a pair of 12 volt HUP Solar 1 batteries 
> to be wired in series.  They don't look like they are particularly 
> designed for a solar installation.
>
> They weigh about 1750 pounds apiece, and and come integrally installed 
> in metal cases.  The metal cases have hinged metal lids.
>
> There is little good access to run conduits to the cases, as the only 
> openings are oblong holes.  The metal cases are very thick, and the 
> battery terminals are very close to the heavy metal.
>
> My question is how can these be safely and code compliantly installed.
>
> To be code compliant, the metal certainly should be grounded, but this 
> would create a hazard due to the fact that all of the terminals would 
> be close to the case, which would become a giant negative terminal.  
> The large batteries have a tremendous amount of punch.
>
> Should the entire "battery" be put in a large plywood box, with the 
> metal battery covers removed?  Should the metal cases be carefully 
> isolated from ground?  What methods have been successfully tried?
>
> Thanks,
>
> Drake
>
> - - - -
> To send a message: RE-wrenches at topica.com
>
> Archive of previous messages: 
> http://lists.topica.com/lists/RE-wrenches/read
>
> List rules & how to change your email address: 
> www.mrsharkey.com/wrenches/etiquette.php
>
> Check out participant bios: www.mrsharkey.com/wrenches/
>
> Hosted by Home Power magazine
>
> Moderator: michael.welch at homepower.com
>
>
>


- - - -
To send a message: RE-wrenches at topica.com

Archive of previous messages: http://lists.topica.com/lists/RE-wrenches/read

List rules & how to change your email address: www.mrsharkey.com/wrenches/etiquette.php

Check out participant bios: www.mrsharkey.com/wrenches/

Hosted by Home Power magazine

Moderator: michael.welch at homepower.com
--^----------------------------------------------------------------
This email was sent to: michael.welch at homepower.com

EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: RE-wrenches-unsubscribe at topica.com

For Topica's complete suite of email marketing solutions visit:
http://www.topica.com/?p=TEXFOOTER
--^----------------------------------------------------------------



</x-flowed>