2 wire to 3 wire generator control [RE-wrenches]

[Allan Sindelar]

Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Need a Laptop? Get a Sony Vaio Laptop Free!
http://click.topica.com/caadtaFbz8Qcsbz9JC9a/ProductTestPanel
-------------------------------------------------------------------

Darryl,
That information is in the SW4024 manual. Pretty much all of the parameters
for 3-wire (Onan-style or Honda-style) are programmable. The manual is
available at http://www.xantrex.com/support/web/prod/176/docdisplay.asp. If
you prefer the older version 2 of the manual, try
http://www.xantrex.com/web/id/307/docserve.asp. Both work with Rev. 4.01
firmware. See the section on "Generator starting details".

If you have the earliest version of the SW firmware, use manual
http://www.xantrex.com/web/id/315/docserve.asp, but you might want to
upgrade the chipset to 4.01.

Allan @+E

 ----- Original Message ----- 
From: "Darryl Thayer" <daryl_solar at yahoo.com>

I would like to ask a related question, how does the
old SW do generator start?  Relay 7 is the run
contacts and relay 8 is the crank contacts.  ( I
think) How does the SW stop cranking when the
generator starts?

My repair customer has system with no diagrams done by
a now disappeared solar installer on a stand alone
system.

When the generator is set for auto and the batteries
get low, the generator cranks and starts.  The starter
stay engaged for a while after the gen starts.  Then
while running for a few minutes perhaps one minute the
starter tries to restart the running engine?

Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Get both the MiFi XM Satellite Radio and an Apple iPod for Free! 
http://click.topica.com/caadtaJbz8Qcsbz9JC9f/ProductTestPanel 
-------------------------------------------------------------------

- - - -
To send a message: RE-wrenches at topica.com

Archive of previous messages: http://lists.topica.com/lists/RE-wrenches/read

List rules & etiquette: www.mrsharkey.com/wrenches/etiquette.php

Check out participant bios: www.mrsharkey.com/wrenches/

Hosted by Home Power magazine

Moderator: michael.welch at homepower.com
--^----------------------------------------------------------------
This email was sent to: michael.welch at homepower.com

EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: RE-wrenches-unsubscribe at topica.com

For Topica's complete suite of email marketing solutions visit:
http://www.topica.com/?p=TEXFOOTER
--^----------------------------------------------------------------