Adding MX60 to Power Panel [RE-wrenches]
Todd Cory, Mt. Shasta Energy Services
toddcory at finestplanet.com
Mon Mar 15 07:10:14 PST 2004
Don't forget tracker electronics too! Been there, done that.
When using a DC250, I always connect DC load CB's to the battery side of the
inverter main, just like the PSDC does.
Todd
Kurt Nelson wrote:
> -----Original Message-----
> From: Jay Peltz, Peltz Power [mailto:jay at asis.com]
>
> There is another issue high voltage damage potential to the inverter....
>
> Yup, where I have seen damage is where DC loads (electronic CFL
> ballasts, LED night-lights, etc) "see" open circuit voltage of the PV.
>
> Kurt Nelson
- - - -
To send a message: RE-wrenches at topica.com
Archive of previous messages: http://www.topica.com/lists/RE-wrenches/
List rules & etiquette: http://www.mrsharkey.com/wrenches/etiquete.htm
Check out participant bios: www.mrsharkey.com/wrenches/index.html
Hosted by Home Power magazine
Moderator: michael.welch at homepower.com
--^----------------------------------------------------------------
This email was sent to: michael.welch at homepower.com
EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: RE-wrenches-unsubscribe at topica.com
For Topica's complete suite of email marketing solutions visit:
http://www.topica.com/?p=TEXFOOTER
--^----------------------------------------------------------------
More information about the RE-wrenches
mailing list