Over current protection for charge controllers [RE-wrenches]
William Miller
wrmiller at slonet.org
Sat May 10 10:15:25 PDT 2003
Friends:
Thanks everyone for the information on this subject. I usually install
upstream and downstream breakers for charge controllers. This is only the
second Power Panel I've installed, and I wondered if Xantrex knew something
I did not.
I installed one DC250 where I had to dremel one of the side breaker slots
larger to accept a 5th breaker for DC loads!
Another complaint I have is the lack of a DC bus positive bus in these
enclosures.
On the other hand, it is sometimes difficult to find room for an Outback PSDC.
William Miller
At 08:20 AM 5/10/2003 -0700, Jay Peltz, Peltz Power wrote:
>Hi Gary,
>
>I never worried about the overcurrent protection as if you short the wires,
>it'll trip the breaker.
>
>What I never liked was that if you shut off the main, then the inverter sees
>( for a moment) open circuit voltage and you cannot shut off the power to
>both sides of the controller with a breaker anyway. Just crazy to me.
>
>I've installed lots of DC disconnects with 4 small breakers, yep gets pretty
>crowded.
__________________________________________________________________
William Miller
Miller Power and Communications
PO Box 50, Santa Margarita, CA 93453
Voice :805-438-5600 Fax: 805-438-4607
email: wrmiller at slonet.org
http://millerpowerandcomm.com
License No. C-10-773985
_____________________________________________________________
Compatibility:
Word processor: WP10
Spreadsheet: Quatro Pro 10
CAD: Microstation 95, DXF, Visio 4.1T
_____________________________________________________________
"Every decent man is ashamed of the government he lives under."
H. L. Mencken
__________________________________________________________________
- - - -
To send a message: RE-wrenches at topica.com
Archive of previous messages: http://www.topica.com/lists/RE-wrenches/
List rules & etiquette: http://www.mrsharkey.com/wrenches/etiquete.htm
Check out participant bios: www.mrsharkey.com/wrenches/index.html
Hosted by Home Power magazine
Moderator: michael.welch at homepower.com
==^================================================================
This email was sent to: michael_welch at sbcglobal.net
EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: RE-wrenches-unsubscribe at topica.com
TOPICA - Start your own email discussion group. FREE!
http://www.topica.com/partner/tag02/create/index2.html
==^================================================================
More information about the RE-wrenches
mailing list