[RE-wrenches] Radian Glitch

[Nick A Lucchese]

Perhaps the re-bulk and re-float settings are too high? AGS settings only enabled for load start? Everything has been working without issue for a significant period up until now? I had something similar on a double Radian system last year. In the Events it appeared that someone had gone in and messed with almost every setting but yet they hadn’t. First time ever that I experienced the inverter being told to turn off without warrant from the Mate3-S. Not uncommon to see the frozen screen which is always remedied by unplugging CAt5 briefly but this was the first un-warranted turn off command I had ever observed.  Outback suspected that the Cat5 cables were corrupted due to all the EMF and suggested I replace all the cables with the shielded varieties. This would be a significant task on this project so I have to take that step. After updating by 1 firmware revision, resetting to defaults and re-programming it went away (fingers crossed). 

Let us know what you find, Nick



> On Jan 13, 2022, at 4:38 AM, Mac Lewis <maclewis1 at gmail.com> wrote:
> 
> Good Morning Wrenches,
> 
> I have an Outback Radian 8048 site that is acting up.  
> 
> This only happens when the generator is automatically started.
> It will start the generator and warm it up normally and then connect and start charging as it should.  After about 30 seconds to 1 minute it will drop the AC input, and put the generator in cool down mode and the charger will be disabled.  It will then continue to run the generator until you turn it off manually, presumably because it hasn't reached the stop trigger.  
> 
> This system will charge normally when the generator is manually started.  The firmware on the Mate3s is up to date.
> 
> Any ideas?
> 
> Thanks in advance
> 
> -- 
> 
> 
> 
> Mac Lewis
> 
> "Yo solo sé que no sé nada." -Sócrates
> 
> _______________________________________________
> List sponsored by Redwood Alliance
> 
> Pay optional member dues here: http://re-wrenches.org
> 
> List Address: RE-wrenches at lists.re-wrenches.org
> 
> Change listserver email address & settings:
> http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
> 
> There are two list archives for searching. When one doesn't work, try the other:
> https://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/
> http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
> 
> List rules & etiquette:
> http://www.re-wrenches.org/etiquette.htm
> 
> Check out or update participant bios:
> http://www.members.re-wrenches.org
> 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.re-wrenches.org/pipermail/re-wrenches_lists.re-wrenches.org/attachments/20220113/727b2abf/attachment.htm>