[RE-wrenches] Mate 3s voltage off

[frenergy]

We're setting up charge points for a new pack of SimpliPhi 3.8 
batteries.  Needed to use the voltage  "offset" function in the FM80's a 
bit to jive with the 2, Fluke 87 meters we got testing the actual 
voltage at the battery bus bars.  However. the Mate3s is reading .6 
volts high and can't find an offset function in the Mate's menus.  
Anybody familiar with the path to get there, if its there?  Assuming the 
Mate uses the voltage readings its showing on the display, this could 
have a significant impact on battery health.  Do I need to calibrate 
both my Flukes?...or buy a new Fluke that's not 22 years old?

Bill

Feather River Solar Electric
Bill Battagin, Owner
4291 Nelson St.
Taylorsville, CA 95983
530.284.7849
CA Lic 874049
www.frenergy.net


-- 
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus