[RE-wrenches] Mixing Outback 100 series C with old FX system

[Dan Fink]

Maybe Brad is referring to the GFDI jumper or the RSS jumper? I don't know
of a jumper to activate comms with the Mate 3S.

The former is for bonding and you remove it if you use an external GFDI,
like a Midnite GFCI in a Midnite MNDC enclosure. It's the little black wire
with 2 red spade connectors under the terminal block.

The RSS jumper you have to make out of a scrap of wire to DIS-able the
Flexmax 100 internal RSS trigger. It goes between the yellow and purple
terminal blocks. If you don't install it, the CC assumes the RSS has been
activated. I love this one for my students, when their homework before lab
class is to *thoroughly* read the instructions and make notes! I can easily
tell if they actually did LOL.

Dan Fink
Owner, Buckville Energy Consulting
NABCEP Certified PV System Inspector
IREC Certified Instructor™ for:
~ PV Installation Professional
~ Small Wind Installer
NABCEP Registered Continuing Education Providers
d <dan.fink at greendustrialtraining.com>anbob88 at gmail.com
970-672-4342


On Sat, Oct 17, 2020 at 8:11 AM Bradley Bassett <bbassett2 at gmail.com> wrote:

> I think there is a jumper in the FM100 that will allow the Mate3s to
> communicate with it. I don't remember off hand where it is and am not at a
> computer with that info, but maybe this will prompt a look at the manual to
> see if they mention it.
>
> Brad
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.re-wrenches.org/pipermail/re-wrenches_lists.re-wrenches.org/attachments/20201019/8e8ff988/attachment.htm>