[RE-wrenches] Slave Radian not showing up on Hub10 or @ Mate3s

[Kirk Herander]

The master-slave config types and port assignments have always been confusing. The quick start guide lists a config where the master is port 1 and the slave is port 7. I believe port 7 is called the sub-master in this config. With only 2 inverters it functions as the slave to the master in port 1. This config has always worked for me.

Hope this is accurate info.
On 6/25/2020 1:35:55 PM, Chris Schaefer <chris at solarandwindfx.com> wrote:
G'Day All,

So I started up a system recently with two Radian 8048A's. The master is connected to port 1 and the slave connected to port 2 with the FlexNet at port 3. There are no OB charge controllers in the system. When the hub is polling (led's scrolling) nothing shows up for the slave at port 2. It's like the slave inverter doesn't exist. So I moved the slave and flexnet down to port 3 and 4. No change in the polling. I swapped out comm (factory green) cables. Again no change. Looking at the control board of the slave there is only one green led on which is located at the upper right-hand side. Otherwise no led's are on. I have 57v at the buss bar terminals of the inverter. Of course since there is no polling at the hub there is no way to view port 2 to view the slave at the Mate.

Now the only thing that I didn't do was to try and use the manual on/off switch-jumper to start the slave. But in the past regardless of the inverter being on or off it would still show up on the hub. This is a new one and I'm looking for some direction here.

Thanks,
Christopher-
Chris Schaefer’s
[http:www.solarandwindfx.com]
Tel/Fax 585-229-2083 or Cell 585-748-1870
5115 South Hill Road ~ Canandaigua New York 14424
www.solarandwindfx.com [http://www.solarandwindfx.com] ~ E-mail: chris at solarandwindfx.com [mailto:chris at solarandwindfx.com]

Thomas Jefferson, the author of our great Constitution, once said, "democracy" will cease to exist when you take away from those who are willing to work and give to those who would not."
_______________________________________________ List sponsored by Redwood Alliance List Address: RE-wrenches at lists.re-wrenches.org Change listserver email address & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org List-Archive: http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html List rules & etiquette: www.re-wrenches.org/etiquette.htm Check out or update participant bios: www.members.re-wrenches.org
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.re-wrenches.org/pipermail/re-wrenches_lists.re-wrenches.org/attachments/20200625/38865bd2/attachment.htm>