[RE-wrenches] Xantrex MPPT 80 600 Not Showing Up in SCP

[Dave Angelini Offgrid Solar]

Hi Jason, 

I would start with the easiest thing first. Since there is
not a device you cant see faults and warnings. disconnect xanbus at mppt.
power down (and disco HV input) for 30 seconds. Repower and see if the
warning light goes out? If mppt does not get found on SCP, 

I would reset
mppt to factory defaults. go into advanced settings mode with just the SCP
and mppt. Hopefully mppt is on the list. 

If you have different symptoms,
post later. Will try and check before happy hour 

Dave Angelini Offgrid
Solar
"we go where powerlines don't"
http://members.sti.net/offgridsolar/
[1]
e-mail offgridsolar at sti.net [2]
text 209 813 0060

On Thu, 16 Apr 2020
16:03:11 -0400, Jason Szumlanski  wrote:   I am working with a client (not
my install) with a XW6048 and MPPT 80 600 with a SCP. The SCP is not
showing the MPPT in the setup menu. I am able to access the system settings
and XW configuration, but not the MPPT settings. It is connected via Xanbus
in this manner:   SCP -> MPPT -> XW   So the MPPT is in the middle and is
passing through the XW signal just fine.   The MPPT also has a red error
light illuminated, but it is charging the battery (positive current
measured via clamp meter).   Any ideas?   Thanks,   Jason Szumlanski       
               

Links:
------
[1]
http://members.sti.net/offgridsolar/
[2] mailto:offgridsolar at sti.net
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.re-wrenches.org/pipermail/re-wrenches_lists.re-wrenches.org/attachments/20200416/0c1740c8/attachment.htm>