[RE-wrenches] Convex modules

[Jerry Shafer]

Module bent or glass warped
OK Kristopher is the glass warped or is the frame bent, looking at the pic,
there is cardboard spacing each module so there is a gap. If the binders
are in the middle then that will bend one or more modules on each side, now
to bend them all the way through that center binder would have to be very
tight or strapped on a truck in shipping. If it is the glass then its
manufacturing and poor QC, my money if it is the frames is shipping and or
packaging, but that's just me.
Jerry

On Sat, Nov 16, 2019, 7:12 AM Kristopher Schmid <solman at legacysolar.com>
wrote:

> So, I opened up a pallet of Jinko 400 watt half cell modules yesterday and
> noticed that every module was convex to the glass side.  The center was 1/4
> inch higher than the corners.  Has anyone else seen this?  Should I be
> concerned?  Manufacturing issue?  Intentional?
>
> Thanks,
> Kris
> _______________________________________________
> List sponsored by Redwood Alliance
>
> List Address: RE-wrenches at lists.re-wrenches.org
>
> Change listserver email address & settings:
> http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
>
> List-Archive:
> http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html
>
> List rules & etiquette:
> www.re-wrenches.org/etiquette.htm
>
> Check out or update participant bios:
> www.members.re-wrenches.org
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.re-wrenches.org/pipermail/re-wrenches_lists.re-wrenches.org/attachments/20191118/01e0710d/attachment.htm>