[RE-wrenches] Mission PVs

[Ryan Harkins]

 Bill,

Sometimes we add some duct tape to the corner guards on the side-stacked module skids, so as you unpack you peel tape back one module at a time.  Helps them stay together as a unit and not tip.

Careful with those Mission modules!  We had a couple skids of those and the corner miters of the frames were off just a little, so the corners of the modules were like razor blades!  They look great though.

Ryan


> On Aug 20, 2019, at 8:31 PM, William Miller <william at millersolar.com> wrote:
> 
> Bill:
> 
> I hope your trailer has side walls.  Load the pallet near one side of your
> trailer.  Encourage modules to lean that direction as you cut the bands.  If
> you are worried about travelling with the load off-center, take some extra
> pallets to stack between the modules and the downhill side of your trailer.
> The panels tend to stand up when the bands are cut.
> 
> William
> 
> Miller Solar
> 17395 Oak Road, Atascadero, CA 93422
> 805-438-5600
> www.millersolar.com
> CA Lic. 773985
> 
> 
> -----Original Message-----
> From: RE-wrenches [mailto:re-wrenches-bounces at lists.re-wrenches.org] On
> Behalf Of Bill Battagin
> Sent: Tuesday, August 20, 2019 6:27 PM
> To: re-wrenches at lists.re-wrenches.org
> Subject: [RE-wrenches] Mission PVs
> 
> Its after hours and I need to load for tomorrow...
> 
> Embarrassing question....  I finally ran out of SolarWorld PVs and just
> received a few pallets of Mission MSE310SQ8T PVs.  They are stacked on
> their edges. hmmm.  I took off the top cardboard, there are still 2
> bands running around the 26 PVs horizontally and the cardboard around
> the sides.  I think only those who have used Mission will know my
> conundrum....What's the next step?
> 
> Thanks,
> 
> Bill
> 
> Feather River Solar Electric
> 
> 
> ---
> This email has been checked for viruses by Avast antivirus software.
> https://www.avast.com/antivirus
> 
> 
> _______________________________________________
> List sponsored by Redwood Alliance
> 
> List Address: RE-wrenches at lists.re-wrenches.org
> 
> Change listserver email address & settings:
> http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
> 
> List-Archive:
> http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html
> 
> List rules & etiquette:
> www.re-wrenches.org/etiquette.htm
> 
> Check out or update participant bios:
> www.members.re-wrenches.org
> _______________________________________________
> List sponsored by Redwood Alliance
> 
> List Address: RE-wrenches at lists.re-wrenches.org
> 
> Change listserver email address & settings:
> http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
> 
> List-Archive: http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html
> 
> List rules & etiquette:
> www.re-wrenches.org/etiquette.htm
> 
> Check out or update participant bios:
> www.members.re-wrenches.org
>