[RE-wrenches] Mission PVs

[William Miller]

Bill:

I hope your trailer has side walls.  Load the pallet near one side of your
trailer.  Encourage modules to lean that direction as you cut the bands.  If
you are worried about travelling with the load off-center, take some extra
pallets to stack between the modules and the downhill side of your trailer.
The panels tend to stand up when the bands are cut.

William

Miller Solar
17395 Oak Road, Atascadero, CA 93422
805-438-5600
www.millersolar.com
CA Lic. 773985


-----Original Message-----
From: RE-wrenches [mailto:re-wrenches-bounces at lists.re-wrenches.org] On
Behalf Of Bill Battagin
Sent: Tuesday, August 20, 2019 6:27 PM
To: re-wrenches at lists.re-wrenches.org
Subject: [RE-wrenches] Mission PVs

Its after hours and I need to load for tomorrow...

Embarrassing question....  I finally ran out of SolarWorld PVs and just
received a few pallets of Mission MSE310SQ8T PVs.  They are stacked on
their edges. hmmm.  I took off the top cardboard, there are still 2
bands running around the 26 PVs horizontally and the cardboard around
the sides.  I think only those who have used Mission will know my
conundrum....What's the next step?

Thanks,

Bill

Feather River Solar Electric


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus


_______________________________________________
List sponsored by Redwood Alliance

List Address: RE-wrenches at lists.re-wrenches.org

Change listserver email address & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org

List-Archive:
http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html

List rules & etiquette:
www.re-wrenches.org/etiquette.htm

Check out or update participant bios:
www.members.re-wrenches.org