Trace/Kohler light flicker [RE-wrenches]

[Kurt Nelson, SunWise]

Greetings Wrenches,

Been following this Kohler thing sorta... Could go to the Meter Menue
and check the hertz while the gen-set is running as well as the voltage
window.  BUT, has anyone mentioned backing off the charge rate.  I think
AC Input Amps default setting could be more than the gen-set can
handle.  Usually, over drawing the gen-set will result in a tripped
breaker on the gen-set (or the fused disconnect device between the
gen-set and the Trace).  However, depending on how it is wired in (or
not) backing off the ac input amps could be the fix?

Kurt Nelson

Joe Schwartz, Home Power wrote:
> 
> Travis,
> 
> >Joe,
> >
> >Go to menu 11 and check the the voltage input window.  It might need to be
> >widened to catch the voltage variances as loads come and go. Is this a
> >Kohler powered 3600 RPM unit?
>


- - - - - - -
To send a message:
 RE-wrenches at topica.com

The archive of previous messages: 
 http://www.topica.com/lists/RE-wrenches/

To unsubscribe send a message to: 
 RE-wrenches-unsubscribe at topica.com

To check out the other RE-Wrench participants:
 www.mrsharkey.com/wrenches/index.html

Hosted by Home Power magazine: 
 www.homepower.com

For info contact list moderator by email:
 michael.welch at homepower.com

___________________________________________________________
T O P I C A  http://www.topica.com/t/17
Newsletters, Tips and Discussions on Your Favorite Topics