Deep water... [RE-wrenches]
Steve Willey, Backwoods Solar
steve at backwoodssolar.com
Tue Jul 4 20:09:43 EDT 2000
That is a lot of lift and a lot of water both. You can always get a big
pump and a huge tank and run the generator to operate the pump, since it
seems it is to be the initial charging source anyway. With that situation
you will want to have large loads all accomplished when the generator is on
using power direct.
If it is to be solar powered eventually, you might look into the Grundfos DC
powered agricultural pumps sold by applied Power in Lacey Washington. I
think they might handle such volumes, not sure. They run on 60 or more volts
array direct and have inverter and AC motor within the sub-pump as I recall.
But big $$
Solar arrays set for high voltage can be switched out of series and into
parallel for 24 or 48 volt charging. A bank of transfer switches DPDT can do
it, or even relays if switching daily when tanks are full. Its a lot of
wiring and potentially troublesome contacts but it has been done.
Just some ideas, I won't suggest which approach from your list is best here
because all seem somewhat intimidating considering that it looks like the
water requirement numbers and the project budget may just not fit together
there.
Steve Willey www.backwoodssolar.com
Backwoods Solar Electric Systems
----- Original Message -----
From: Gary Higbee, Solutions from the Land <ghigbee at efn.org>
To: <RE-wrenches at topica.com>
Sent: Tuesday, July 04, 2000 3:56 PM
Subject: Deep water... [RE-wrenches]
. We've got a lift of about 425' from the water in the well to
> the big tank. We'd also like as close to 5,000 gallons per day as
possible.
> At this point my client understands this will greatly exceed his budget,
but
> would still like to get at least 2,000 gallons per day. I'll give you a
few
> parameters and pose a few questions:
- - - - - - -
To send a message to the list use: <RE-wrenches at topica.com>
To view an archive of previous messages go to: <http://www.topica.com/lists/RE-wrenches/
To unsubscribe send an email message to: <RE-wrenches-unsubscribe at topica.com>
To check out who the other RE-Wrench participants are, go to <http://www.mrsharkey.com/wrenches/>
Hosted by Home Power magazine: <http://www.homepower.com>
for info contact: <michael.welch at homepower.com>
___________________________________________________________
T O P I C A The Email You Want. http://www.topica.com/t/16
Newsletters, Tips and Discussions on Your Favorite Topics
More information about the RE-Wrenches
mailing list