[RE-wrenches] Metal roof multi-fastener attachment
August Goers
august at luminalt.com
Mon Aug 29 08:51:38 PDT 2016
Hi Daryl,
You might check out S-5 VersaBrackets and RibBrackets:
http://www.s-5.com/clamps/index_71.cfm
http://www.s-5.com/clamps/ribbracket/index_5336.cfm
-August
-----Original Message-----
From: RE-wrenches [mailto:re-wrenches-bounces at lists.re-wrenches.org] On
Behalf Of penobscotsolar at midmaine.com
Sent: Sunday, August 28, 2016 5:13 AM
To: RE-wrenches
Subject: [RE-wrenches] Metal roof multi-fastener attachment
Hi all,
I have some possibilities of reasonable size commercial jobs where the
buildings have "corrugated" type roofs with purlins run underneath which
are worst case 16 gauge steel. On steel roofs I typically use #14 Marutex
stainless screws but in this case the job is in the Caribbean and there is
a high risk of hurricanes. We use Snap N Rack but their steel roof
attachment has only a single screw attachment point.
What I am looking for is a metal roof attachment that will mate with
Snap N Rack materials and that has multi attchment points at each
attachment point. It would go on the flat area of the metal roof between
the "corrugations".
Does anyone have any suggestions? I can get the Marutex screws with
rubber gaskets.
Thanks,
Daryl
_______________________________________________
List sponsored by Redwood Alliance
List Address: RE-wrenches at lists.re-wrenches.org
Change listserver email address & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
List-Archive:
http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.htm
l
List rules & etiquette:
www.re-wrenches.org/etiquette.htm
Check out or update participant bios:
www.members.re-wrenches.org
More information about the RE-wrenches
mailing list