[RE-wrenches] How to isolate the array DC

[Jerry Shafer]

Ours does something has to do it
Jerry
On Feb 2, 2015 11:37 AM, "Glenn Burt" <glenn.burt at glbcc.com> wrote:

> I only read where it is necessary to provide the operation of rapid
> shutdown
> and the system be labeled accordingly, not that it needs a dedicated switch
> to perform the function.
>
> Glenn
>
> -----Original Message-----
> From: RE-wrenches [mailto:re-wrenches-bounces at lists.re-wrenches.org] On
> Behalf Of Mark Frye
> Sent: Monday, February 02, 2015 4:24 PM
> To: RE-wrenches
> Subject: [RE-wrenches] How to isolate the array DC
>
> In order to clear up the conversation...
>
> I you put a relay in a box within 10 feet of the array on the roof, you can
> use an relay with a DC rated Normally Open contact to open and
> connect/isolate the array DC voltage.
>
> You can drive the coil of that relay with either AC or DC, but either way,
> if you lose voltage to drive the coil, the contact opens and isolates.
>
> My point is, for simple grid-tied system, there is no need for a "stop"
> switch anywhere in the system. It doesn't matter whether the contactor coil
> is driven by the premise AC or by a DC power supply connected to the
> premise
> AC, when the the main is opened or the meter pulled, the array Dc will
> become isolate.
>
> Therefore, there is no need for the "stop" switch and yet as I understand
> it, such a switch is now required by the Code. The switch is not needed but
> is required.
>
> Mark Frye
> _______________________________________________
> List sponsored by Redwood Alliance
>
> List Address: RE-wrenches at lists.re-wrenches.org
>
> Change listserver email address & settings:
> http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
>
> List-Archive:
> http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html
>
> List rules & etiquette:
> www.re-wrenches.org/etiquette.htm
>
> Check out or update participant bios:
> www.members.re-wrenches.org
>
> _______________________________________________
> List sponsored by Redwood Alliance
>
> List Address: RE-wrenches at lists.re-wrenches.org
>
> Change listserver email address & settings:
> http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
>
> List-Archive:
> http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html
>
> List rules & etiquette:
> www.re-wrenches.org/etiquette.htm
>
> Check out or update participant bios:
> www.members.re-wrenches.org
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org/attachments/20150202/2e206156/attachment-0002.html>