[RE-wrenches] Foam Insulation Install
jay peltz
jay at asis.com
Mon Jul 19 07:57:25 PDT 2010
How is the plywood attached to the foam?
jay
peltz power
On Jul 19, 2010, at 7:50 AM, Glenn Burt wrote:
> Can you see where the rafter tails were nailed at the soffit?
> How is the ridge constructed? A vent you could lift to see the ridge end of
> the rafters?
>
> Good Luck!
> -Glenn Burt
>
> -----Original Message-----
> From: re-wrenches-bounces at lists.re-wrenches.org
> [mailto:re-wrenches-bounces at lists.re-wrenches.org] On Behalf Of
> holtek at sbcglobal.net
> Sent: Monday, July 19, 2010 9:59 AM
> To: RE-wrenches
> Subject: [RE-wrenches] Foam Insulation Install
>
> For residential install with the spray foam insulation
>
> Underside of deck has 12"+ of foam.....no way to accurately locate rafter
> there.....hammer and ear also out of the question...........don't think any
> of the stud finders will work....been told that peeling back shingles to
> locate rafter is only accurate way.......would like to avoid that if
> possible..........any suggestions?
>
> Holt E. Kelly
> Holtek Fireplace & Solar Products
> 500 Jewell Dr.
> Waco TX. 76712
> 254-751-9111
> www.holteksolar.com
>>
>>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org/attachments/20100719/591170b2/attachment-0004.html>
More information about the RE-wrenches
mailing list