Equalizing battery charger [RE-wrenches]
Drake Chamberlin
Drake.Chamberlin at redwoodalliance.org
Sat Jan 5 13:27:18 PST 2008
<x-flowed>
HI Nick,
My IOTA DLS 45 only had tape over the pot, and the charge voltage
dropped from 14.8 to around 14.0 over time. I was wondering if
vibration had caused the drift.
Drake
At 02:37 PM 1/3/2008, you wrote:
>Once that is off you can access the pot and scrape the adhesive
>layer off around it so that it turns freely. Not sure if this is a
>supposed to act as a deterrent or possibly prevent the pot from
>turning due to vibration. I did also recently notice one that I had
>previously set to 14.7 bulk putting out 15.1 vdc without the jumper
- - - -
Hosted by Home Power magazine
To send a message: RE-wrenches at topica.com
Archive of previous messages: http://lists.topica.com/lists/RE-wrenches/read
List rules & how to change your email address: www.mrsharkey.com/wrenches/etiquette.php
Check out participant bios: www.mrsharkey.com/wrenches/
Moderator: michael.welch at homepower.com
--^----------------------------------------------------------------
This email was sent to: michael.welch at re-wrenches.org
EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: re-wrenches-unsubscribe at topica.com
For Topica's complete suite of email marketing solutions visit:
http://www.topica.com/?p=TEXFOOTER
--^----------------------------------------------------------------
</x-flowed>
More information about the RE-wrenches
mailing list