grundfos sqflex [RE-wrenches]
Jay Peltz, Peltz Power
jay at asis.com
Thu Jun 26 08:11:56 PDT 2008
<x-flowed>
Hi Allan,
So you left the "bottom" open as the main water entry?
jay
peltz power
On Jun 25, 2008, at 4:01 PM, Allan Sindelar wrote:
>
> Jay,
> We recently installed a 1/2hp Grundfos SQ AC sub in a rainwater
> tank, using
> a method recommeded by our well supply house. It is essentially
> like Windy's
> advice. We used a 4' piece of 4" PVC well casing and a standard 4"
> sanitary
> seal on one end. This gave us pipe and wire attachment and sealed
> one end.
> It also allowed the intake water to flow over the pump, cooling it.
> I glued
> a scrap of PVC casing inside the sleeve to hold the pump centered,
> and set
> the sleeve on bricks to keep it above collected debris.
>
> Allan at Positive Energy
>
> -----Original Message-----
> From: Windy Dankoff [mailto:windydankoff at mac.com]
>
> Hi Jay.
> This is NOT advice specific to the SQFlex. I can only advise about
> submersible pumps in general. Here goes:
>
> When placing a pump in open water (pond, tank, dug well) as opposed to
> in a narrow well casing, there is not much water flow immediately
> surrounding the motor. Because of that, the motor may be susceptible
> to overheating. To aggravate the matter, surface water can get quite
> warm, further reducing the cooling effect. This is regardless of
> vertical or horizontal position. The fix is to place the pump in a
> sleeve of pipe or tube to simulate the water flow in a casing.
>
> The SQFlex has a more efficient motor than conventional pumps. It
> therefore produces less heat and I suppose it has a heat sensor built-
> in as well. So, I suspect that this may not be an issue. You may wish
> to seek further advice but I thought I'd fill you in on the reasoning
> at least.
>
> Windy
>
>>
- - - -
Hosted by Home Power magazine
To send a message: RE-wrenches at topica.com
Archive of previous messages: http://lists.topica.com/lists/RE-wrenches/read
List rules & how to change your email address: www.mrsharkey.com/wrenches/etiquette.php
Check out participant bios: www.mrsharkey.com/wrenches/
Moderator: michael.welch at homepower.com
--^----------------------------------------------------------------
This email was sent to: michael.welch at re-wrenches.org
EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: RE-wrenches-unsubscribe at topica.com
For Topica's complete suite of email marketing solutions visit:
http://www.topica.com/?p=TEXFOOTER
--^----------------------------------------------------------------
</x-flowed>
More information about the RE-wrenches
mailing list