Flexible Conduit [RE-wrenches]

[Andrew Truitt]

<x-flowed>

Mark - I don't think so.  I think the code limits bends to 360 degrees
between accessible pull-cans not just for the initial pull, but also
in case re-wiring is ever needed.  I'm no code expert, however, though
I did just pass the NABCEP!

Andrew Truitt
Standard Solar Inc.



On 5/16/07, Mark Frye <markf at berkeleysolar.com> wrote:
>
> If I pre-load conductors into a flexible conduit while it's striaght, prior
> to pulling it thought the framing, can I exceed 360 degrees of bending once
> it is in place?
>
> MPF
>
>
> - - - -
> To send a message: RE-wrenches at topica.com
>
> Archive of previous messages: http://lists.topica.com/lists/RE-wrenches/read
>
> List rules & how to change your email address: www.mrsharkey.com/wrenches/etiquette.php
>
> Check out participant bios: www.mrsharkey.com/wrenches/
>
> Hosted by Home Power magazine
>
> Moderator: michael.welch at homepower.com
>
>
>
>


- - - -
To send a message: RE-wrenches at topica.com

Archive of previous messages: http://lists.topica.com/lists/RE-wrenches/read

List rules & how to change your email address: www.mrsharkey.com/wrenches/etiquette.php

Check out participant bios: www.mrsharkey.com/wrenches/

Hosted by Home Power magazine

Moderator: michael.welch at homepower.com
--^----------------------------------------------------------------
This email was sent to: michael_welch at sbcglobal.net

EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: RE-wrenches-unsubscribe at topica.com

For Topica's complete suite of email marketing solutions visit:
http://www.topica.com/?p=TEXFOOTER
--^----------------------------------------------------------------

</x-flowed>