MX 60 Max Amps [RE-wrenches]
Jay Peltz, Peltz Power
jay at asis.com
Sat Apr 14 08:02:17 PDT 2007
<x-flowed>
Hi David,
It will do up to 70 amps, depending on its temp.
Use a 70 amp breaker, but remember that if using #6 wire you might be
outside of NEC limits.
And set the amp limit in the correct screen.
jay
peltz power
On Apr 14, 2007, at 7:50 AM, David Palumbo, Independent Power & Light
wrote:
>
> Question on MX performance with the following off-grid 24v battery
> system.
>
> (8) Sanyo 195w HIP-BA3's (all in parallel) 68v Voc (55vpMax) input
> voltage
> to MX 60. Cold climate installation (-40 F winter lows, 95 F summer
> highs).
> 1,560 watt array. MX 60 manual says the MX60 can handle 1,600
> watts. It also
> says the Output Current Rating is 60 amps "continuous" @ 25C ambient.
>
> My question is. Will the REV 7 MX 60's put out greater than 60 amps
> for
> short periods of time?
>
> Dave
>
>
> - - - -
> To send a message: RE-wrenches at topica.com
>
> Archive of previous messages: http://lists.topica.com/lists/RE-
> wrenches/read
>
> List rules & how to change your email address: www.mrsharkey.com/
> wrenches/etiquette.php
>
> Check out participant bios: www.mrsharkey.com/wrenches/
>
> Hosted by Home Power magazine
>
> Moderator: michael.welch at homepower.com
>
>
>
>
- - - -
To send a message: RE-wrenches at topica.com
Archive of previous messages: http://lists.topica.com/lists/RE-wrenches/read
List rules & how to change your email address: www.mrsharkey.com/wrenches/etiquette.php
Check out participant bios: www.mrsharkey.com/wrenches/
Hosted by Home Power magazine
Moderator: michael.welch at homepower.com
--^----------------------------------------------------------------
This email was sent to: michael.welch at homepower.com
EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: RE-wrenches-unsubscribe at topica.com
For Topica's complete suite of email marketing solutions visit:
http://www.topica.com/?p=TEXFOOTER
--^----------------------------------------------------------------
</x-flowed>
More information about the RE-wrenches
mailing list