minimum clearances [RE-wrenches]
Allan Sindelar
allan at positiveenergysolar.com
Mon Feb 12 09:14:52 PST 2007
Marco,
We faced this same issue recently on a 25kW utility job. There is no minimum
height specified for service equipment in the NEC that applies to your
question. Something in trailer parks, I think.
Allan at PosE
----- Original Message -----
From: "Marco Mangelsdorf" <marco at pvthawaii.com>
>
> I've got an install using several SMA 6000s. I know what the clearances
for
> the working spaces for electrical equipment are: 36" in front, 30" wide,
and
> 6'6" high. The SB6000 inverters need 8" clearance around them. Does anyone
> know what the minimum clearances are as far as mounting an inverter off
the
> floor as far as the NEC is concerned? Is it 3", 12", 36" or nothing at
all?
> How about an inverter AC output load center? Same thing as any
distribution
> panel I would think. I can't find anything to say what the min. or max.
> would be off the floor though. I know a manually operated disco handle can
> not be higher than 6'7" without some special attachments. I thought there
> was a min of 36" for the handle in the off position off the floor. I just
> can't seem to find it in the code. Any ideas?
>
- - - -
To send a message: RE-wrenches at topica.com
Archive of previous messages: http://lists.topica.com/lists/RE-wrenches/read
List rules & how to change your email address: www.mrsharkey.com/wrenches/etiquette.php
Check out participant bios: www.mrsharkey.com/wrenches/
Hosted by Home Power magazine
Moderator: michael.welch at homepower.com
--^----------------------------------------------------------------
This email was sent to: michael.welch at homepower.com
EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: RE-wrenches-unsubscribe at topica.com
For Topica's complete suite of email marketing solutions visit:
http://www.topica.com/?p=TEXFOOTER
--^----------------------------------------------------------------
More information about the RE-wrenches
mailing list