Equalizing battery charger [RE-wrenches]
Jay Peltz, Peltz Power
jay at asis.com
Sun Dec 23 13:13:41 PST 2007
<x-flowed>
HI Drake,
I've never seen the iota go to the 14.8 with the RJ11 pluged in.
If you look on the end with the fan, you should see a small 1/4"
round sticker. If you peal this back you will find a small pot that
you can adjust up to around 15.5v depending on the exact model. ( to
adjust disconnect the DC load turn it on and adjust it, pretty easy.
On Dec 23, 2007, at 3:04 PM, Drake Chamberlin wrote:
>
> At 11:50 AM 12/23/2007, you wrote:
>> If you have a DLS series you can purchase the IQ4 and plug it in the
>> RJ11 on top of the converter for 3 stage charging. If you have a
>> really
>> old model without the RJ11 you can get a hardwired model of the IQ4.
>
> Hi Larry,
>
> I have a DLS 45, and the RJ11 is plugged in. Do you know of any
> way to get the 14.8 volts bulk back?
>
> Thanks,
>
> Drake
>
>
> - - - -
> Hosted by Home Power magazine
>
> To send a message: RE-wrenches at topica.com
>
> Archive of previous messages: http://lists.topica.com/lists/RE-
> wrenches/read
>
> List rules & how to change your email address: www.mrsharkey.com/
> wrenches/etiquette.php
>
> Check out participant bios: www.mrsharkey.com/wrenches/
>
> Moderator: michael.welch at homepower.com
>
>
>
- - - -
Hosted by Home Power magazine
To send a message: RE-wrenches at topica.com
Archive of previous messages: http://lists.topica.com/lists/RE-wrenches/read
List rules & how to change your email address: www.mrsharkey.com/wrenches/etiquette.php
Check out participant bios: www.mrsharkey.com/wrenches/
Moderator: michael.welch at homepower.com
--^----------------------------------------------------------------
This email was sent to: michael.welch at re-wrenches.org
EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: RE-wrenches-unsubscribe at topica.com
For Topica's complete suite of email marketing solutions visit:
http://www.topica.com/?p=TEXFOOTER
--^----------------------------------------------------------------
</x-flowed>
More information about the RE-wrenches
mailing list