balancing a three phase panel [RE-wrenches]
Mike Bernhard
spaight12 at sbcglobal.net
Sat Jun 2 03:44:53 PDT 2007
<x-flowed>
Geoff,
There are references in the NEC but they are vague. It says there can't be
"too much imbalance". You are always better off trying to create three
phases to feed into a three phase panel, but your assumption that there can
be some imbalance is correct. In the traditional electrical world,
electricians "balance" a panel for output loads with varying degrees of
success.
Mike Bernhard
- - - -
Hosted by Home Power magazine
To send a message: RE-wrenches at topica.com
Archive of previous messages: http://lists.topica.com/lists/RE-wrenches/read
List rules & how to change your email address: www.mrsharkey.com/wrenches/etiquette.php
Check out participant bios: www.mrsharkey.com/wrenches/
Moderator: michael.welch at homepower.com
--^----------------------------------------------------------------
This email was sent to: michael_welch at sbcglobal.net
EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: RE-wrenches-unsubscribe at topica.com
For Topica's complete suite of email marketing solutions visit:
http://www.topica.com/?p=TEXFOOTER
--^----------------------------------------------------------------
</x-flowed>
More information about the RE-wrenches
mailing list