setting wind tower screw in anckors [RE-wrenches]

[Roy Butler, Four Winds RE]

<x-flowed>

Hi Darryl,

One word answer......concrete!

Seriously.....I've never trusted the screw in anchors, so I dig to just 
below the frost line, lay the anchor in (with rebar/ remesh as needed) 
and pour concrete in the hole.

Trust me....you'll sleep better on windy nights with this method!

Roy Butler
NABCEP Certified Solar PV Installer®
NYSERDA eligible PV & wind installer 
Four Winds Renewable Energy, LLC
8902 Route 46
Arkport, NY 14807
607-324-9747
www.four-winds-energy.com



Darryl Thayer wrote:

>HI
>What do folks use to set wind tower screw-in anckors? 
>By hand is just so hard, and a post hole digger spins
>to fast.  Thanks 
>Darryl
>
>__________________________________________________
>Do You Yahoo!?
>Tired of spam?  Yahoo! Mail has the best spam protection around 
>http://mail.yahoo.com 
>
>
>- - - -
>To send a message: RE-wrenches at topica.com
>
>Archive of previous messages: http://lists.topica.com/lists/RE-wrenches/read
>
>List rules & how to change your email address: www.mrsharkey.com/wrenches/etiquette.php
>
>Check out participant bios: www.mrsharkey.com/wrenches/
>
>Hosted by Home Power magazine
>
>Moderator: michael.welch at homepower.com
>
>
>
>
>  
>


- - - -
To send a message: RE-wrenches at topica.com

Archive of previous messages: http://lists.topica.com/lists/RE-wrenches/read

List rules & how to change your email address: www.mrsharkey.com/wrenches/etiquette.php

Check out participant bios: www.mrsharkey.com/wrenches/

Hosted by Home Power magazine

Moderator: michael.welch at homepower.com
--^----------------------------------------------------------------
This email was sent to: michael.welch at homepower.com

EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: RE-wrenches-unsubscribe at topica.com

For Topica's complete suite of email marketing solutions visit:
http://www.topica.com/?p=TEXFOOTER
--^----------------------------------------------------------------


</x-flowed>