Need Xantrex help (again) [RE-wrenches]

[Christopher Freitas --- OutBack Power]

Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Save up to 67% on Omaha Steaks + Get 6 FREE Burgers and a 
FREE Cutlery Set + Cutting Board!
http://click.topica.com/caacpgjbz8Qcsbz9JC9a/OmahaSteaks
-------------------------------------------------------------------

Bill Brooks wrote:
> William didn't state that this was a dual inverter situation. If it is 
> not, the Square-D solution should work just fine--agreed? The wiring may 
> be a little odd, but not that bad for a single inverter.

Yes - that is correct, Bill - I was jumping to conclusions that it was a 
dual inverter system since he wanted the Xantrex enclosure so much 
(which probably meant lots of breakers).  It is a nice enclosure for 
holding the QOU breakers - Bill Hoffer designed it and did a very good 
job on it - lots of access to the breaker terminals. 

For single inverter applications the SquareD three phase box works well 
- for dual inverter applications you need two seperate boxes.  This 
makes it a bit messy in my opinion and opens up all kinds of possible 
problems with other certain brands of series stacked inverters (but not 
mine...).  I don't think separate bypasses for each leg should be 
considered acceptable - what is your thought on this, Bill? Others?  

Christopher Freitas
OutBack Power Systems, Inc.
cfreitas @ outbackpower.com  
www.outbackpower.com
Arlington WA USA
Tel 360 435 6030  

Your free subscription is supported by today's sponsor:
-------------------------------------------------------------------
Sponsor a child today through Children International.  
Give a desperately poor child hope for a brighter future.
For only $18 a month you can make a difference!
http://click.topica.com/caacpgsbz8Qcsbz9JC9f/ChildrenInternational
-------------------------------------------------------------------

- - - -
To send a message: RE-wrenches at topica.com

Archive of previous messages: http://lists.topica.com/lists/RE-wrenches/read

List rules & etiquette: www.mrsharkey.com/wrenches/etiquete.htm

Check out participant bios: www.mrsharkey.com/wrenches/

Hosted by Home Power magazine

Moderator: michael.welch at homepower.com
--^----------------------------------------------------------------
This email was sent to: michael.welch at homepower.com

EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: RE-wrenches-unsubscribe at topica.com

For Topica's complete suite of email marketing solutions visit:
http://www.topica.com/?p=TEXFOOTER
--^----------------------------------------------------------------