DR question [RE-wrenches]
Christopher Freitas - OutBack Power
cfreitas at outbackpower.com
Tue Aug 26 23:40:43 PDT 2003
You should check the RMS voltage and peak AC voltage when the inverter
is running with a light and heavy load. The RMS voltage should be
120VAC +/- 10V under all conditions but the peak voltage should be
between 180V and 140V. There are a couple of failure modes that can
result in the behavior you are seeing.
Most likely it needs a new FET board. Getting someone with a O-scope to
check it is probably the best way to check it.
Christopher Freitas
OutBack Power Systems, Inc.
cfreitas at outbackpower.com www.outbackpower.com
Tel 360 435 6030 Arlington WA USA
jay peltz wrote:
>
> Hi All,
>
> I've got a DR inverter that is doing the following.
>
> When voltage above around 13.8v ( 12v system) the inverter will not run
> electronic items, it'll do lights and toaster etc, but not the TV, radio
> etc.
>
> Any ideas? or is this back to the factory?
>
> thanks,
>
> jay
>
> Peltz Power
>
>
>
- - - -
To send a message: RE-wrenches at topica.com
Archive of previous messages: http://www.topica.com/lists/RE-wrenches/
List rules & etiquette: http://www.mrsharkey.com/wrenches/etiquete.htm
Check out participant bios: www.mrsharkey.com/wrenches/index.html
Hosted by Home Power magazine
Moderator: michael.welch at homepower.com
--^----------------------------------------------------------------
This email was sent to: michael_welch at sbcglobal.net
EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: RE-wrenches-unsubscribe at topica.com
TOPICA - Start your own email discussion group. FREE!
http://www.topica.com/partner/tag02/create/index2.html
--^----------------------------------------------------------------
More information about the RE-wrenches
mailing list