wires allowed on cir. bkr. terminals [RE-wrenches]
Jeff Yago
jryago at earthlink.net
Thu Jul 31 15:02:11 PDT 2003
I think this may have been covered before but could not find.
Inspector dis-allowed two #14 romex cable wires (small exhaust fan
circuit & small light circuit in solar room) on same Sq. D. QO 15 amp
cir. bkr. terminal in a sub-panel.
Code Section 110-14(a) "terminals for more than one conductor shall be
so identified".
Sq. D. parts book says the terminal for this circuit breaker is OK for
one or two wires up to size #10, and is designed with indention on
both sides of compression screw to hold one wire on each side. What
gives ?
Jeff Yago
- - - -
To send a message: RE-wrenches at topica.com
Archive of previous messages: http://www.topica.com/lists/RE-wrenches/
List rules & etiquette: http://www.mrsharkey.com/wrenches/etiquete.htm
Check out participant bios: www.mrsharkey.com/wrenches/index.html
Hosted by Home Power magazine
Moderator: michael.welch at homepower.com
--^----------------------------------------------------------------
This email was sent to: michael_welch at sbcglobal.net
EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: RE-wrenches-unsubscribe at topica.com
TOPICA - Start your own email discussion group. FREE!
http://www.topica.com/partner/tag02/create/index2.html
--^----------------------------------------------------------------
More information about the RE-wrenches
mailing list