Need help selecting an inverter [RE-wrenches]
Darryl Thayer
daryl_solar at yahoo.com
Sat Aug 23 18:24:36 PDT 2003
Hi everyone
I have a system design problem.
I have a system that needs 240 volt to start and run a
7-HP motor with full load current of 30 amps. And
carry a 10-amp 240-volt motor load. One leg of this
also has to start a ¾ HP 9 amp 120-volt full load
pump. With miscellaneous loads such that one leg has
45 amps total and the other leg has 55 amps total.
The operation of the 7 HP motor is only for 2 to 3
minutes then off for 20 minutes up to several hours.
However under extreame condition, it could run up to
30 % duty cycle.
I tried two SW5548 and they seem to work but on start
of the 7-HP motor will some times kick on overload.
What do more experienced people than I do in this
case? I have other use for the SWs. I do not know if
a soft start will work.
Do you think two stacked sets of two FX3648 (or what
ever the new vented Outback is numbered) inverters
would serve the purpose? Should I use an
auto-transformer to balance this load?
What other inverters might work from a 48 volt battery
set? Can other inverters use the auto-transformer?
Daryl
__________________________________
Do you Yahoo!?
Yahoo! SiteBuilder - Free, easy-to-use web site design software
http://sitebuilder.yahoo.com
- - - -
To send a message: RE-wrenches at topica.com
Archive of previous messages: http://www.topica.com/lists/RE-wrenches/
List rules & etiquette: http://www.mrsharkey.com/wrenches/etiquete.htm
Check out participant bios: www.mrsharkey.com/wrenches/index.html
Hosted by Home Power magazine
Moderator: michael.welch at homepower.com
--^----------------------------------------------------------------
This email was sent to: michael_welch at sbcglobal.net
EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: re-wrenches-unsubscribe at topica.com
TOPICA - Start your own email discussion group. FREE!
http://www.topica.com/partner/tag02/create/index2.html
--^----------------------------------------------------------------
More information about the RE-wrenches
mailing list