MC PV closure [RE-wrenches]

[Graham Owen]

Bob,

It certainly would be nice to only install UL listed components, 
especially ones that have current passing through the center of them.  I 
will most likely use the MC clamps to keep the kid in the future who is 
pulling a ball or other object out from under an array from also pulling 
apart a connection.  I had been using flex conduit between modules, but 
that is not UL compliant.  Short of putting EMT with a path to ground on 
each section between modules, I don’t know of a better way?

I had been thinking about purchasing the tools to make my own MC's and 
the instructions state that the wire must be tinned.  I have samples 
from other sources, which I pulled appart, and the wire is not tinned.  
This is probably not UL compliant?

Graham

- - - -
To send a message: RE-wrenches at topica.com

Archive of previous messages: http://www.topica.com/lists/RE-wrenches/

List rules & etiquette: http://www.mrsharkey.com/wrenches/etiquete.htm

Check out participant bios: www.mrsharkey.com/wrenches/index.html

Hosted by Home Power magazine

Moderator: michael.welch at homepower.com

==^================================================================
This email was sent to: michael.welch at homepower.com

EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9.bWljaGFl
Or send an email to: RE-wrenches-unsubscribe at topica.com

T O P I C A -- Register now to manage your mail!
http://www.topica.com/partner/tag02/register
==^================================================================