slip rings [RE-wrenches]
hugh piggott
hugh.piggott at enterprise.net
Thu Jul 12 09:44:10 PDT 2001
<x-flowed>
At 11:12 am -0600 12/7/01, Windy Dankoff, Dankoff Solar wrote:
>
>We were surprised and disappointed to find that the cable twisting
>was frequent. It seems that the shift of winds, perhaps some
>nearly-daily shift, seemed to always cause rotation in the same
>direction, or whatever might explain it.
It is wise to allow enough length and flexibility in the cable hang
for 100 twists to accumulate without stress. This is easy to do. I
know of a site where there will be approximately 300 twists per year,
and in that circumstance we have a problem. However I do believe
that the vast majority of sites will have no problem over a five year
period, and to be honest I don't think about it that much. But
mention it to someone from the USA and they spend the next week
devising ever more elaborate solutions to a problem with (for the
most part) does not exist.
It sounds as if sliprings should be fitted as standard in the USA if
only to end the discussion :-) But I personally would not buy them
if I could save 10% on wind turbine price. Or if they did not look
beefy enough for me. Corrosion, overheating, slack yaw bearings
causing damage, contamination with oil/grease, there is plenty to go
wrong along that road.
>
>It would be good now to ask the manufacturers if they have had
>complaints from particular locations, using cable system. I'm not
>directly involved in this right now, but I pass this on to be of
>help.
thanks :-)
--
Hugh
http://www.ScoraigWind.co.uk
- - - -
To send a message: RE-wrenches at topica.com
Archive of previous messages: http://www.topica.com/lists/RE-wrenches/
List rules & etiquette: http://www.mrsharkey.com/wrenches/etiquete.htm
Check out participant bios: www.mrsharkey.com/wrenches/index.html
Hosted by Home Power magazine
Moderator: michael.welch at homepower.com
==^================================================================
EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9
Or send an email To: RE-wrenches-unsubscribe at topica.com
This email was sent to: michael.welch at homepower.com
T O P I C A -- Register now to manage your mail!
http://www.topica.com/partner/tag02/register
==^================================================================
</x-flowed>
More information about the RE-wrenches
mailing list