Frigidare Washer [RE-wrenches]

blair Tump may tump at midcoast.com
Fri May 25 17:40:11 PDT 2001


<x-flowed>

>  replace the DR with a SW.

>  But I will also caution folks to watch out for poor quality GFIC plugs 
> that these washers plug into. We had a washer that wouldn't cycle and 
> swaped controllers in the washer and only when removing the washer and 
> trying it w/ a cord that had the grounding pin cut off ( replace it 
> tommorrow) did it work. Shi_ luck, but a valuable lesson.


>What do you think? Any first-hand accounts to offer?
>
>Thanks,
>
>Gary
>
>~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
>      Gary Higbee  (ghigbee at efn.org)
>              (541)607-1818
>      Solutions from the Land--solar,
>   wind, and hydro site analysis, design,
>        and installation assistance
>~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
>
>
>- - - -
>To send a message: RE-wrenches at topica.com
>
>Archive of previous messages: http://www.topica.com/lists/RE-wrenches/
>
>List rules & etiquette: http://www.mrsharkey.com/wrenches/etiquete.htm
>
>Check out participant bios: www.mrsharkey.com/wrenches/index.html
>
>Hosted by Home Power magazine
>
>Moderator: michael.welch at homepower.com
>
Solarwinds NorthernLights
Serving Mid Coast Maine & Northern California
          610-517-8401              707-498-2804









- - - -
To send a message: RE-wrenches at topica.com

Archive of previous messages: http://www.topica.com/lists/RE-wrenches/

List rules & etiquette: http://www.mrsharkey.com/wrenches/etiquete.htm

Check out participant bios: www.mrsharkey.com/wrenches/index.html

Hosted by Home Power magazine

Moderator: michael.welch at homepower.com

==^================================================================
EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Qcs.bz9JC9
Or send an email To: RE-wrenches-unsubscribe at topica.com
This email was sent to: michael.welch at homepower.com

T O P I C A -- Register now to manage your mail!
http://www.topica.com/partner/tag02/register
==^================================================================

</x-flowed>



More information about the RE-wrenches mailing list