SW4024 switching issue [RE-wrenches]
Kirk Herander, VT Solar
vtsolar1 at together.net
Wed Feb 7 15:59:22 PST 2001
S-
I haven't been able to connect Trace tech support yet(their new phone menus are
wonderful fun). Do you know if these relays are socket-mount or soldered on the board?
thanks, Kirk
"R. Sparks Scott" wrote:
> Kirk;
>
> Consider that it might be time to replace the transfer relays in the
> Trace. If the system used to transfer just fine, it could be that the
> relays are beginning to have wear on the contacts, or perhaps the steel
> core in the coil be becoming magnetized, causing the relay to "hang" just
> long enough to prevent the transfer from happening quickly enough.
> Weakening of the springs that cause the relays' (there are two in parallel)
> armatures to return to the normally-closed position when the Trace gives
> the logic command to switch back to invert might be a factor.
> Another thing to add to the now-too-late wish list. Logic port to send
> voltage to an external (perhaps 100+ amp) transfer relay.
> None of that considers that there may be some problem with the electronics
> of the inverter as well, such as a distorted waveform at low/no load, under
> voltage without load, phase difference between load and generator, etc.
> Have you checked to see that the generator is running at exactly 60 Hz? How
> is the generator voltage??? Low?? High?? Try to set the generator voltage
> to be equal to the inverter's operating voltage.
> Best of luck.
>
> -S
>
> - - - - - - -
> To send a message:
> RE-wrenches at topica.com
>
> The archive of previous messages:
> http://www.topica.com/lists/RE-wrenches/
>
> To unsubscribe send a message to:
> RE-wrenches-unsubscribe at topica.com
>
> To check out the other RE-Wrench participants:
> www.mrsharkey.com/wrenches/index.html
>
> Hosted by Home Power magazine:
> www.homepower.com
>
> For info contact list moderator by email:
> michael.welch at homepower.com
>
> ____________________________________________________________
> T O P I C A -- Learn More. Surf Less.
> Newsletters, Tips and Discussions on Topics You Choose.
> http://www.topica.com/partner/tag01
- - - - - - -
To send a message:
RE-wrenches at topica.com
The archive of previous messages:
http://www.topica.com/lists/RE-wrenches/
To unsubscribe send a message to:
RE-wrenches-unsubscribe at topica.com
To check out the other RE-Wrench participants:
www.mrsharkey.com/wrenches/index.html
Hosted by Home Power magazine:
www.homepower.com
For info contact list moderator by email:
michael.welch at homepower.com
____________________________________________________________
T O P I C A -- Learn More. Surf Less.
Newsletters, Tips and Discussions on Topics You Choose.
http://www.topica.com/partner/tag01
More information about the RE-wrenches
mailing list