[RE-wrenches] Trace 4024 cutting out
frenergy
frenergy at psln.com
Mon Oct 18 11:11:33 EDT 2021
Chris and Jerry,
Sorry, I forgot to mention I did exactly that, had the
Fluke clipped to the + and (-) of the pack and watched it as load was
applied. Yes, voltage fell but never got below ~24.4V when the inverter
output stopped. Checked tightness of all battery connections, terminal
to terminal cables, virtually no corrosion anywhere. Also, inverter
stayed ON, just the output cut-out, then back on then off, then......
Bill
Feather River Solar Electric
Bill Battagin, Owner
4291 Nelson St.
Taylorsville, CA 95983
530.284.7849
CA Lic 874049
www.frenergy.net
On 10/18/2021 7:14 AM, Jerry Shafer wrote:
> Look at the batteries, use a meter right at the bolts going in to the
> inverter, sounds like low voltage cut out.
>
> On Sun, Oct 17, 2021, 9:07 PM frenergy <frenergy at psln.com> wrote:
>
> Hey Folks,
>
> I haven't seen this one until yesterday. Customer with a
> 20 year old Trace SW4024 called. I've been servicing this reliable
> system for the last 8 years. He said after a delay the power
> shuts off
> when a moderate load comes on after 5-15 seconds, then back on, then
> off..... Light loads no problem, the power stays on. The inverter
> stays on the entire time (yellow light and that famous audio buzz)
> but I
> hear a relay? inside the left side of the wiring section with each
> change of on-off, off-on state. I assume its a repair to a service
> shop. Ideas? Recommendations for repair shops? I haven't been
> getting
> a response from the Solar Cowboyz in Grass Valley.
>
> Thanks,
>
> Bill
>
> Feather River Solar Electric
> Bill Battagin, Owner
> 4291 Nelson St.
> Taylorsville, CA 95983
> 530.284.7849
> CA Lic 874049
> solar powered since 1982
>
>
--
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.re-wrenches.org/pipermail/re-wrenches_lists.re-wrenches.org/attachments/20211018/e0db1eb2/attachment.htm>
More information about the RE-Wrenches
mailing list