[RE-wrenches] Trimetric with Outback

[frenergy]

Wrenchers,

             I tried asking OB about this, no response.  New FlexPwer2 
installed in customer's basement, I like to keep the Mate with the 
system because the basement is my access point for future programming, 
troubleshooting, etc (rather than entering the house which many times is 
unoccupied)...no internet or cell service onsite.

             To have some system status info in the house for the 
customer I would like to install a Trimetric 2030 upstairs.  This looks 
a bit tricky with three shunts in the DC enclosure to monitor various 
in/outputs for the FNDC to function and display info properly for the 
Mate.  Where-o-where might the sense wire be connected to properly 
measure *NET *amps flowing hither and fro to supply the correct info for 
the Trimetric?  The picture should help, the two cables coming off the 
bottom (right side) of shunt "B" are inverter negs.

Bill

Feather River Solar Electric
Bill Battagin, Owner
4291 Nelson St.
Taylorsville, CA 95983
530.284.7849
CA Lic 874049
www.frenergy.net



-- 
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.re-wrenches.org/pipermail/re-wrenches_lists.re-wrenches.org/attachments/20201122/ca2a2111/attachment.htm>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: OB FP2 shunts oic.pdf
Type: application/pdf
Size: 495343 bytes
Desc: not available
URL: <http://lists.re-wrenches.org/pipermail/re-wrenches_lists.re-wrenches.org/attachments/20201122/ca2a2111/attachment.pdf>