[RE-wrenches] Pulsing with AC coupling
Mac Lewis
maclewis1 at gmail.com
Tue Aug 25 13:59:53 EDT 2020
Hi Drake,
Do you have the AC coupling firmware in the Radian? It should be at
least Required
Firmware 001.006.070
This is a good place to start:
http://outbackpower.com/downloads/documents/appnotes/acc_freq_app_note.pdf
I have seen better results programming the Freq Shift Response Time to the
lower end ie ~0.05s.
Which micro version is it? Is it freq/watt capable?
On Tue, Aug 25, 2020 at 10:09 AM <drake.chamberlin at redwoodalliance.org>
wrote:
> P.S. The Radian is set to phase shift, and it reliably shuts off micro
> inverters at set point voltages. The issues occur at lower battery voltage,
> below the set points for the phase shift.
> ---
>
>
>
> On 2020-08-25 11:20, drake.chamberlin at redwoodalliance.org wrote:
>
> The inverter is set to ON not to SEARCH. If the Enphase circuit is
> switched off, the pulsing stops immediately. This system has both AC and DC
> coupling.
>
> In another location, with a Sunny Boy AC coupled with a pair of stacked
> VFX3524 inverters, there is some pulsing in low light conditions. The
> Radian and Enphase combo is much more noticeable.
> ---
>
>
>
> On 2020-08-25 10:42, Jerry Shafer wrote:
>
> Wrenches
> I would think that in time there might be damage. Check to make sure the
> inverter is not on search but I stead "ON", next if you turn off the
> enphase the the outback perform normally. Check the inverter frequency to
> see your frequency is shifting have one that has both AC & DC Coupling and
> no issues.
>
> On Tue, Aug 25, 2020, 6:37 AM <drake.chamberlin at redwoodalliance.org>
> wrote:
>
> Hello Wrenches,
>
> An AC coupled arrangement, with an 8 kW Radian and 8 Enphase
> microinverters, pulses lighting at low levels of array illumination.
> This is generally not too much of a problem.
>
> Under certain levels of solar isolation, the pulsing becomes extreme and
> causes the motors in the refrigerator and air-conditioner to pulse,
> sometimes causing very audible vibrations.
>
> Will this harm the appliances? Is there anything that can be done to
> moderate or stop the pulsing?
>
> Thank you,
>
> Drake
> Athens Electric LLC
>
> --
> _______________________________________________
> List sponsored by Redwood Alliance
>
> List Address: RE-wrenches at lists.re-wrenches.org
>
> Change listserver email address & settings:
> http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
>
> List-Archive:
> http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
>
> List rules & etiquette:
> www.re-wrenches.org/etiquette.htm
>
> Check out or update participant bios:
> www.members.re-wrenches.org
>
>
> _______________________________________________
> List sponsored by Redwood Alliance
>
> List Address: RE-wrenches at lists.re-wrenches.org
>
> Change listserver email address & settings:
> http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
>
> List-Archive:
> http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
>
> List rules & etiquette:
> www.re-wrenches.org/etiquette.htm
>
> Check out or update participant bios:
> www.members.re-wrenches.org
>
>
> _______________________________________________
> List sponsored by Redwood Alliance
>
> List Address: RE-wrenches at lists.re-wrenches.org
>
> Change listserver email address & settings:
> http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
>
> List-Archive:
> http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
>
> List rules & etiquette:
> www.re-wrenches.org/etiquette.htm
>
> Check out or update participant bios:
> www.members.re-wrenches.org
>
> _______________________________________________
> List sponsored by Redwood Alliance
>
> List Address: RE-wrenches at lists.re-wrenches.org
>
> Change listserver email address & settings:
> http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
>
> List-Archive:
> http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
>
> List rules & etiquette:
> www.re-wrenches.org/etiquette.htm
>
> Check out or update participant bios:
> www.members.re-wrenches.org
>
>
--
Mac Lewis
*"Yo solo sé que no sé nada." -Sócrates*
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.re-wrenches.org/pipermail/re-wrenches_lists.re-wrenches.org/attachments/20200825/d274411c/attachment.htm>
More information about the RE-Wrenches
mailing list