[RE-wrenches] SW fault code low output voltage

[Mac Lewis]

What kind of load is on this system?  Any oddball loads that may strange
power factor?

On Thu, Aug 22, 2019 at 7:15 PM <bruce at willpowerelect.com> wrote:

> Group,
>
> I'm not very familiar with Schneider equipment, but would like to
> understand fault code 00F1 on a CSW 4024.
> Low voltage output. Any remedy? Have reset several times but fault
> continues. Inverter only two years old.
> Tech support wouldn't take my call 'cause I'm not on their 'certified'
> list.
>
> Thanks!
>
> Bruce Fiero
>
> P: 541.535.3965
> F: 541.512.0061
> E: bruce at willpowerelect.com
> W: Willpower Electric, LLC <http://www.willpower-electric.com>
>
> CCB 191852
> Oregon Electrical Contractor C681
> NABCEP Certified Solar (PV) Installer 031409-38
> DUNS 191470363
> Energy Trust of Oregon Trade Ally Solar (PV) Installation & Energy
> Efficient Commercial Lighting Programs
>
>
> _______________________________________________
> List sponsored by Redwood Alliance
>
> List Address: RE-wrenches at lists.re-wrenches.org
>
> Change listserver email address & settings:
> http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
>
> List-Archive:
> http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html
>
> List rules & etiquette:
> www.re-wrenches.org/etiquette.htm
>
> Check out or update participant bios:
> www.members.re-wrenches.org
>
>

-- 



Mac Lewis

*"Yo solo sé que no sé nada." -Sócrates*
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.re-wrenches.org/pipermail/re-wrenches_lists.re-wrenches.org/attachments/20190822/bce8a7b0/attachment.htm>