[RE-wrenches] Cutting rail

[Jeremy Rodriguez]

Pre cut the rails at ground level with your circular saw.

Jeremy Rodriguez
Solar Installation / Design Expert
All Solar, Inc.
1463 M St
Penrose Colorado 81240

Sent by Jeremy's iPhone. Sorry for typos and shorthand.

On Jun 12, 2019, at 11:32 PM, frenergy <frenergy at psln.com<mailto:frenergy at psln.com>> wrote:

Any suggestions for cutting rail with a Sawzall?  Many times at the end of a run of PVs there could be 5-6" of rail (in this case DPW P8).  I like to use a circular saw but sometimes I don't have enough clearance once the rail and panels are installed.  The sawzall works but I'm looking for a blade that doesn't load up with aluminum too fast and cuts without too much vibration.  Other ideas?

Thanks,

Bill

Feather River Solar Electric
Bill Battagin, Owner
4291 Nelson St.
Taylorsville, CA 95983
530.284.7849
CA Lic 874049
www.frenergy.net<http://www.frenergy.net>


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus


_______________________________________________
List sponsored by Redwood Alliance

List Address: RE-wrenches at lists.re-wrenches.org<mailto:RE-wrenches at lists.re-wrenches.org>

Change listserver email address & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org

List-Archive: http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html

List rules & etiquette:
www.re-wrenches.org/etiquette.htm<http://www.re-wrenches.org/etiquette.htm>

Check out or update participant bios:
www.members.re-wrenches.org<http://www.members.re-wrenches.org>

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.re-wrenches.org/pipermail/re-wrenches_lists.re-wrenches.org/attachments/20190613/445cdc1a/attachment.htm>