[RE-wrenches] Cutting rail

[Kirpal]

Just like the other gents mentioned...but I would add...get the saw blade
with 10 teeth per inch....will not clog up with the soft aluminum.   You
will love the saw for cutting conduit too.  All done relatively quietly
without all the jarring.
Kirpal

On Wed, Jun 12, 2019, 9:32 PM frenergy <frenergy at psln.com> wrote:

> Any suggestions for cutting rail with a Sawzall?  Many times at the end
> of a run of PVs there could be 5-6" of rail (in this case DPW P8).  I
> like to use a circular saw but sometimes I don't have enough clearance
> once the rail and panels are installed.  The sawzall works but I'm
> looking for a blade that doesn't load up with aluminum too fast and cuts
> without too much vibration.  Other ideas?
>
> Thanks,
>
> Bill
>
> Feather River Solar Electric
> Bill Battagin, Owner
> 4291 Nelson St.
> Taylorsville, CA 95983
> 530.284.7849
> CA Lic 874049
> www.frenergy.net
>
>
> ---
> This email has been checked for viruses by Avast antivirus software.
> https://www.avast.com/antivirus
>
>
> _______________________________________________
> List sponsored by Redwood Alliance
>
> List Address: RE-wrenches at lists.re-wrenches.org
>
> Change listserver email address & settings:
> http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
>
> List-Archive:
> http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html
>
> List rules & etiquette:
> www.re-wrenches.org/etiquette.htm
>
> Check out or update participant bios:
> www.members.re-wrenches.org
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.re-wrenches.org/pipermail/re-wrenches_lists.re-wrenches.org/attachments/20190612/a04e6cce/attachment.htm>