<div dir="auto"><div>I have a situation with a utility company that requires us to have a single visible load break disconnect switch that isolates only the &quot;renewable sources&quot; without disconnecting the house loads. To do this, the only way possible seems to be combining the inverters in a load center and then using the main lugs in the load center to go to a fusible disconnect switch, and then the backup load lugs in the Gateway 3. </div><div dir="auto"><br></div><div dir="auto">The problem with that is I have not been able to find a 125 amp load center that accepts multiple backfed breaker fasteners. Square D has a 100 amp load center that accepts two breaker hold down kits, but for two Powerwalls we need 125A. </div><div dir="auto"><br></div><div dir="auto">Other than going to a panel board with bolt on breakers, can you think of any other way to comply?</div><div dir="auto"><br></div><div dir="auto">Jason Szumlanski </div><div dir="auto">Florida Solar Design Group </div><div dir="auto">We</div><div dir="auto"><br></div><div data-smartmail="gmail_signature"><div dir="ltr"><div dir="ltr"><div dir="ltr"><div dir="ltr"><div dir="ltr"><div dir="ltr"><b><div style="text-align:center"><table border="0" cellpadding="0" cellspacing="0" style="color:rgb(34,34,34);font-weight:400;text-align:start;font-family:&quot;helvetica neue&quot;,helvetica,arial,sans-serif"><tbody></tbody></table></div></b></div></div></div></div></div></div></div></div>