<div dir="auto">Greetings All,<div dir="auto"><br></div><div dir="auto">I have inherited a stand alone system at a state park originally installed by Currin Corporation out of Michigan (I think that he did work in a number of state parks in the region).  Good install, but the custom designed 72 volt controller (a Canadian company that slips my mind at the moment) crapped out.  I replaced it with a 72 volt midnite controller and all is well except...</div><div dir="auto">The original system used a dc relay to disconnect the 72 volt dc submersible well pump.  I kept the relay in the circuit controlled by the midnite aux port.  Since I was unable to read any programming from the old controller, I am not sure where to set the cut-in and cut-out voltages for the pump relay.</div><div dir="auto">Battery bank: 12 Deka MK 8G27 (72 volts, 176 ah)</div><div dir="auto">Pump current: unknown at the moment</div><div dir="auto"><br></div><div dir="auto">Anyone?</div><div dir="auto"><br></div><div dir="auto">Thanks,</div><div dir="auto">Kris</div></div>