<div dir="auto">Jay<div dir="auto">Just finished using S5PV railess on standing seam roof 12x12 pitch. Worked great, but wire management was challenging with minimal clearance under modules. Had to think ahead to make it work. And still was a struggle. I also used 6 rather then 4 per module to even out the loads on the roof panels. I feel confident that it is solid, but I know how the roof was connected to include proper clip spacing and screw size for maximum wind load here in the Columbia Gorge and proper tacking of the top of the panel under the ridge to prevent sliding down. If I had it to do over I would however have used rails to make wire management easier!</div><div dir="auto"><br></div><div dir="auto">Bill</div></div><br><div class="gmail_quote"><div dir="ltr">On Fri, Mar 30, 2018, 6:03 PM jay <<a href="mailto:jay.peltz@gmail.com" target="_blank" rel="noreferrer">jay.peltz@gmail.com</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">HI All,<br>
<br>
I\u2019ve got a client who is set on wanting to do rail less racking. I\u2019m just working with him on overall design, hes doing the work.<br>
<br>
Its not a large system. 16 modules on two roof orientations, ( 4 on one, 12 on the other) with offset modules. Standing metal seam roof that is being installed with solar in mind, lots of fasteners.<br>
<br>
Hes very competent and pays attention to details.<br>
<br>
Any positive/negative recommendations.<br>
<br>
thanks in advance,<br>
<br>
jay<br>
<br>
peltz power<br>
<br>
<br>
_______________________________________________<br>
List sponsored by Redwood Alliance<br>
<br>
List Address: <a href="mailto:RE-wrenches@lists.re-wrenches.org" rel="noreferrer noreferrer" target="_blank">RE-wrenches@lists.re-wrenches.org</a><br>
<br>
Change listserver email address & settings:<br>
<a href="http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org" rel="noreferrer noreferrer noreferrer" target="_blank">http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org</a><br>
<br>
List-Archive: <a href="http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html" rel="noreferrer noreferrer noreferrer" target="_blank">http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html</a><br>
<br>
List rules & etiquette:<br>
<a href="http://www.re-wrenches.org/etiquette.htm" rel="noreferrer noreferrer noreferrer" target="_blank">www.re-wrenches.org/etiquette.htm</a><br>
<br>
Check out or update participant bios:<br>
<a href="http://www.members.re-wrenches.org" rel="noreferrer noreferrer noreferrer" target="_blank">www.members.re-wrenches.org</a><br>
<br>
</blockquote></div>