<div dir="ltr">If you have access to the rafters, we clamp two welding magnets to the rafter with a woodworkers clamp, and run another over the top. The magnets are setup to repel, so the rafter is the low point between the magnets.</div><div class="gmail_extra"><br><div class="gmail_quote">On Sun, May 10, 2015 at 9:02 AM, Matt Partymiller <span dir="ltr">&lt;<a href="mailto:matt@solar-energy-solutions.com" target="_blank">matt@solar-energy-solutions.com</a>&gt;</span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">We have tried a number of products.  The D-Tect is in amazing stud finder<br>
but did very little on shingle roofs.  The mechanism by which you run it<br>
across a surface is clearly not made for shingles.  It is basically a<br>
$1000 sculpture on the top shelf in our shop.<br>
<br>
I am still not aware of any great method for identifying rafters.<br>
<br>
<br>
On Sun, May 10, 2015 12:40 am, SES wrote:<br>
&gt; Pleeeeease don&#39;t reply offlist.  I would kill for a rooftop rafter finder<br>
&gt; that points to anything but me.<br>
&gt;<br>
&gt; Sent from my iPad<br>
&gt;<br>
&gt;<br>
&gt;&gt; On May 9, 2015, at 11:42 AM, Mick Abraham &lt;<a href="mailto:mick@abrahamsolar.com">mick@abrahamsolar.com</a>&gt;<br>
<div><div class="h5">&gt;&gt; wrote:<br>
&gt;&gt;<br>
&gt;&gt;<br>
&gt;&gt; Hello, Mechanix~<br>
&gt;&gt;<br>
&gt;&gt;<br>
&gt;&gt; &quot;Sub Scanner&quot; was mentioned a couple of seasons back so I wonder if<br>
&gt;&gt; those who &quot;bought in&quot; could &quot;weigh in&quot; with their opinions? My main<br>
&gt;&gt; goal is to scan through composition shingles and find the trusses for<br>
&gt;&gt; anchor points...with no goofs. Also I&#39;d like to find wall studs when<br>
&gt;&gt; scanning through synthetic stucco &amp; exterior rigid foam insulation.<br>
&gt;&gt;<br>
&gt;&gt; Bosch D-Tect 150 is a more costly version in this glorified &quot;stud<br>
&gt;&gt; finder&quot; category; that one seems to have a bigger display and no need<br>
&gt;&gt; for calibration. Could I get user opinions on that?<br>
&gt;&gt;<br>
&gt;&gt; ...and then DeWalt had their version which picked up some bad reviews<br>
&gt;&gt; and I think that was replaced with a new model so now I&#39;m thoroughly<br>
&gt;&gt; confused but looking for installer opinions on these type products.<br>
&gt;&gt;<br>
&gt;&gt; Contact me &quot;off List&quot; if there&#39;s an extra scanner-gizmo available for<br>
&gt;&gt; purchase or for lease. Thanks in advance. The Wrench List is the Bomb!<br>
&gt;&gt;<br>
&gt;&gt; Mick Abraham, Proprietor<br>
&gt;&gt; <a href="http://www.abrahamsolar.com" target="_blank">www.abrahamsolar.com</a><br>
&gt;&gt;<br>
&gt;&gt; Voice: <a href="tel:970-731-4675" value="+19707314675">970-731-4675</a><br>
</div></div>&gt;&gt; _______________________________________________<br>
&gt;&gt; List sponsored by Redwood Alliance<br>
&gt;&gt;<br>
&gt;&gt;<br>
&gt;&gt; List Address: <a href="mailto:RE-wrenches@lists.re-wrenches.org">RE-wrenches@lists.re-wrenches.org</a><br>
&gt;&gt;<br>
&gt;&gt;<br>
&gt;&gt; Change listserver email address &amp; settings:<br>
&gt;&gt; <a href="http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org" target="_blank">http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org</a><br>
&gt;&gt;<br>
&gt;&gt;<br>
&gt;&gt; List-Archive:<br>
&gt;&gt; <a href="http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist" target="_blank">http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist</a>.<br>
&gt;&gt; html<br>
&gt;&gt;<br>
&gt;&gt; List rules &amp; etiquette:<br>
&gt;&gt; <a href="http://www.re-wrenches.org/etiquette.htm" target="_blank">www.re-wrenches.org/etiquette.htm</a><br>
&gt;&gt;<br>
&gt;&gt; Check out or update participant bios:<br>
&gt;&gt; <a href="http://www.members.re-wrenches.org" target="_blank">www.members.re-wrenches.org</a><br>
&gt;&gt;<br>
&gt; _______________________________________________<br>
&gt; List sponsored by Redwood Alliance<br>
&gt;<br>
&gt;<br>
&gt; List Address: <a href="mailto:RE-wrenches@lists.re-wrenches.org">RE-wrenches@lists.re-wrenches.org</a><br>
&gt;<br>
&gt;<br>
&gt; Change listserver email address &amp; settings:<br>
&gt; <a href="http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org" target="_blank">http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org</a><br>
&gt;<br>
&gt;<br>
&gt; List-Archive:<br>
&gt; <a href="http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.ht" target="_blank">http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.ht</a><br>
&gt; ml<br>
&gt;<br>
&gt; List rules &amp; etiquette:<br>
&gt; <a href="http://www.re-wrenches.org/etiquette.htm" target="_blank">www.re-wrenches.org/etiquette.htm</a><br>
&gt;<br>
&gt; Check out or update participant bios:<br>
&gt; <a href="http://www.members.re-wrenches.org" target="_blank">www.members.re-wrenches.org</a><br>
&gt;<br>
&gt;<br>
<br>
<br>
Matthew Partymiller<br>
Solar Energy Solutions LLC<br>
<a href="tel:%28877%29%20312-7456" value="+18773127456">(877) 312-7456</a><br>
<a href="mailto:matt@solar-energy-solutions.com">matt@solar-energy-solutions.com</a><br>
<br>
<br>
_______________________________________________<br>
List sponsored by Redwood Alliance<br>
<br>
List Address: <a href="mailto:RE-wrenches@lists.re-wrenches.org">RE-wrenches@lists.re-wrenches.org</a><br>
<br>
Change listserver email address &amp; settings:<br>
<a href="http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org" target="_blank">http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org</a><br>
<br>
List-Archive: <a href="http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html" target="_blank">http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html</a><br>
<br>
List rules &amp; etiquette:<br>
<a href="http://www.re-wrenches.org/etiquette.htm" target="_blank">www.re-wrenches.org/etiquette.htm</a><br>
<br>
Check out or update participant bios:<br>
<a href="http://www.members.re-wrenches.org" target="_blank">www.members.re-wrenches.org</a><br>
<br>
</blockquote></div><br><br clear="all"><div><br></div>-- <br><div class="gmail_signature"><div dir="ltr">Chris Mason<div><div style="color:rgb(136,136,136)"><span style="font-size:13px">NABCEP Certified Solar PV Installer\u2122</span></div><div style="color:rgb(136,136,136)"><span style="color:rgb(34,34,34)">Solar Design Engineer</span></div><div style="color:rgb(136,136,136)"><span style="font-size:13px">Generac Generators Industrial technician</span></div></div><div style="color:rgb(136,136,136)"><span style="font-size:13px"><br></span></div><div><a href="http://www.cometenergysystems.com" target="_blank">www.cometsolar.com</a></div><div>264.235.5670</div><div>869.662.5670</div><div>Skype: netconcepts</div></div></div>
</div>