<div dir="ltr"><div>You may want to contact the gen set manufacture to see if the genny can go cold "freeze protection" at sub zero because it may be required to operate 24/7in that condition. you may be able to install a thermostat to control the block heater, this way its not always on. PS I would use the Outback products.<br></div>Jerry<br></div><div class="gmail_extra"><br><div class="gmail_quote">On Thu, Apr 2, 2015 at 4:47 PM, Gary Higbee <span dir="ltr"><<a href="mailto:gary@windstreamsolar.com" target="_blank">gary@windstreamsolar.com</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">Wrenches,<br>
<br>
I'm curious what strategies you use to preheat a propane gen in cold climates. This is a large off-grid design in a sub-zero winter climate and ideal would be to turn on a block heater an hour or two in advance, then run the gen cycle. We plan to use either a Schneider XW or Outback Radian configuration (still very interested in which you'd use and why). We could set up a logic/relay system to first send the gen request to the heater for a while and then turn off and initiate a gen cycle but that would eliminate the ability for autostart on short notice. I've read of heat lamps on a thermostat, just wondering if you have seen other solutions.<br>
<br>
Thanks!<br>
<br>
Gary<br>
_______________________________________________<br>
List sponsored by Redwood Alliance<br>
<br>
List Address: <a href="mailto:RE-wrenches@lists.re-wrenches.org">RE-wrenches@lists.re-wrenches.org</a><br>
<br>
Change listserver email address & settings:<br>
<a href="http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org" target="_blank">http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org</a><br>
<br>
List-Archive: <a href="http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html" target="_blank">http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html</a><br>
<br>
List rules & etiquette:<br>
<a href="http://www.re-wrenches.org/etiquette.htm" target="_blank">www.re-wrenches.org/etiquette.htm</a><br>
<br>
Check out or update participant bios:<br>
<a href="http://www.members.re-wrenches.org" target="_blank">www.members.re-wrenches.org</a><br>
<br>
</blockquote></div><br></div>